Share
Pin
Tweet
Send
Share
Send
A traditional stand-up collar is a hallmark of a shirt blouse. Here you can see how to do it right.
FIRST STITCH A COLLAR ...![](http://img.ballardsicecream.com/img/burd-2020/1236/rubashechnij-vorotnik.jpg)
• Bend the lower collar with an arc. Chop the outer sections of the collar at a distance of approx. 5 cm from the ends, the seam lines should not be aligned.
![](http://img.ballardsicecream.com/img/burd-2020/1236/rubashechnij-vorotnik-2.jpg)
• Stitch external sections of the collar from the bottom of the collar. Cut allowances close to the line, cut diagonally at the corners.
• To make it easier to iron the edges of the collar after eversion, iron the seam allowances - this is best done using a wooden spoon handle or an unvarnished pencil (4).
• Unscrew the collar, but do not squeeze the corners out with a sharp object, and carefully pull them out with the pin (5) from the front side of the collar.
![](http://img.ballardsicecream.com/img/burd-2020/1236/rubashechnij-vorotnik-3.jpg)
Tip
On shirt collars, a gasket reinforces both rack parts and one collar part. Important: on thin, transparent and translucent fabrics this is the upper collar (to allow for
the outer edges of the collar were not visible). On thicker fabrics, the lower collar is reinforced with a spacer.
... THEN THE COLLAR STAP TO THE STAND ...
• Push the collar face-to-face from the mid-front line to the mid-front line on one part of the collar stand (= outer stand) so that the lower collar is at the bottom.
![](http://img.ballardsicecream.com/img/burd-2020/1236/rubashechnij-vorotnik-4.jpg)
Sew only to the marked line of the neckline, and unscrew the ironed allowance on the inside stand again (6).
![](http://img.ballardsicecream.com/img/burd-2020/1236/rubashechnij-vorotnik-5.jpg)
• Cut off the allowances and cut them into roundings. Do not yet turn the collar upright: first, unscrew the inside of the upward position on the stitching seam and iron it (7).
Then unscrew the outer part up and iron it. In conclusion, unscrew the rack
and iron the front ends of the collar.
... AND AT THE END OF THE STAND, TURN INTO THE NECK.
• Insert the outer collar stand face-to-face into the neck without grabbing allowances at the front ends of the stand. To embroider. Cut allowances close to the line, cut (8) and zatyut-
live on a rack.
![](http://img.ballardsicecream.com/img/burd-2020/1236/rubashechnij-vorotnik-6.jpg)
Share
Pin
Tweet
Send
Share
Send